Upgrade Instructions

These Firmware Upgrade instructions are for the following players :

WARNING : FAILURE TO FOLLOW THESE INSTRUCTIONS CORRECTLY MAY RESULT IN A DAMAGED AND UNUSABLE DVD PLAYER !!! WE ACCEPT NO RESPONSIBILTY FOR ANY DAMAGE CAUSED TO YOUR PLAYER BY USING THIS UPGRADE CD.

1) Plug in the mains and press the "Power" button on the front panel

2) Power up from standby using the "on/off" button on the remote 

3) Open the tray using the remote and remove any discs

4) Put the upgrade disc in the drawer

5) On the remote press and hold the "6" key whilst pressing and holding the "REC" button on the front panel , keep both buttons held for at least 5 seconds , nothing will APPEAR to happen.

6) Release these buttons and press "Open / Close" on the front panel - nothing should happen , if the drawer closes then go back to step 3.

7) Close the drawer by pushing it lightly by hand

8) After a few seconds "ROM WRITE START" will appear in the top left hand corner of the TV.

9) Do not touch the unit during this procedure until the player ejects the disc ( after a few minutes)

10) Remove the upgrade disc and unplug the unit from the mains for around 1 minute

11) When you plug the unit back in it will be Multiregion.